NOTES:
*It forbids to spray at people and to be used by children, as it could hurt anyone in 40centimeters.
*Make it sure it is connected to the earth firmly before using.
*It is not allowed to use the gun outdoors in raining days,
in order to keep from Hurting by leak, which may be caused by thunder ou damp.
*Do not spray liquid that is easy to burn. Keep it in vented condition.
And use it in correct way that is stiulated by law material manufactures.
*Take off the power when you finish.
*If the gun is used more than 3days once,put some lubricant on the cylinder to keep from rutting.

Use the raw materials：
Select the pure spray gun oil carefully . Recommend using three chlorine ethane to steep oil,
branch water or other neutral liquid that can totally volatilize . Using second spray gun oil or
bad oil mix product is easy to damage parts and dress material again.

Method :
1.Press the button for about 5 sell. It sprays.
2.Take a distance from 10cm to 30cm with the material. Softer
the material is, further the gun sets.
3.The water button 22 is less powerful in clockwise rotation
and more powerful in
anti-clockwise rotation.
4.When cleans, do it from outer border to inner.
5.Use the adjusting ring of series 23. Model DA-170 to adjust
the suck-water point.
Fix the hole to the center (picture 9). It has already done then you get it. But if you adjust it by yourself, make it sure in the hole.

Upkeep methods:
When it finishes,sray again with the mixture of 5-10% oil and menstrual to keep from rusting of the cylinder.
Every 5 gallon liquid needs 5 drops lubrication. Once the gun sprays with water,
it needs some lubrication when it finishes.

Malfunction clearing methods：
1.The motor is not workable with weak electric current sound.
Cause: The cylinder rusts because of long disuse. Or the cylinder spring transforms.
Methods: Take off the cylinder and nozzle. If the spring trans-
forms, change it for another one. If the cylinder rusts, and the front bar is not movable,
use a 3.8mm chopstick or round stick to move it at the nozzle side with lubrication. Then fix it back.
2.The liquid splits or stops in the course of operation, with weak motor sound.
Cause: The gun sucks something wrong in and it blocks the nozzle.
Methods: Take off the nozzle, clean it with wind gun. Take care when you u-
se hard metal needle to clean the nozzle, for it is likely to be damaged.
3.Motor operates well but it can not suck the liquid in.

Methods:
(1).check whether if the splitting piston is fired well and check whether
if the splitting piston spring is work well.
(2).check whether the suck tube is loose or not.
(3).check whether if the water control button is off adjust it to the right position.